We do offer a Class II hitches that will fit your 2004 Pontiac Grand Prix, but the ground clearance on these hitches will be less than your current hitch. The chances of contact with your driveway would be higher.
An option that you may consider would be to use a trunk mounted bike rack. If you are only using the hitch for carrying your bikes, then the trunk mounted hitch will remove the issue of contact with your driveway.
A trunk mounted rack that I recommend that is a confirmed fit... view full answer...
If you look at some of the other pictures of Fender # PF11X35W-2 you will see that it has somewhat of a cut out on either side at the back but they are for the included mounting brackets. The same goes for the Fulton fenders but they do not come with mounting brackets.
Clearance lights can be surface mounted to the outside of the fenders. Rectangular lights measuring from 2-1/2 to 4 inches long seem to be the most popular for this application. view full answer...
The Curt Class II 1-1/4 Inch Trailer Hitch Receiver, # C12225, would be a good option for your 2001 Pontiac Grand Prix GT. This hitch has a tongue weight capacity of 350 pounds. Tongue weight capacity is the maximum amount of weight that can be safely suspended from a hitch and the use of a hitch adapter like # HTAD will reduce a vehicle's tongue weight capacity by 50 percent.
The only hitches that are available for the 2001 Grand Prix GT are Class II which has the 1-1/4 inch receiver.
You... view full answer...
As long as the spoiler was factory installed and not an aftermarket option on your 2004 Pontiac Grand Prix, then you may want to take a look at the Thule Gateway 2 Bike Rack, # TH88VR. I can tell you that Thule does not test fit their bike racks of vehicles with spoilers, but they designed this bike rack to fit over most OEM spoilers.
If you were looking for a guaranteed fit, then the best option is to add a trailer hitch and use a hitch mounted bike rack. The advantages to using a hitch... view full answer...
We had the opportunity to test fit hitches on the Pontiac Grand Prix and found that the Curt Hitch # C12225 has just 7 1/2 inches of clearance from the bottom of the receiver to the ground.
The Curt Hitch # C12225 has a nice powder coat finish that tends to hold up better than that used by other brands, so the hitch will better fight rust and scratches. For the installation, it will be helpful to have a nylon tube brush like # 814092 and some spray lubricant for cleaning out the weld... view full answer...
The most popular transmission cooler for your 2006 Pontiac Grand Prix is the Derale part # D13503 which also requires the fitting part # D13035. The best way to pick out a cooler is to go with the largest one that fits in front of your vehicle radiator.
This one measures 11" Wide x 8-3/4" tall x 7/8" deep. view full answer...
You would need wire that is flexible enough to wrap around the bolt threads without coming loose. Annealed Stove wire works great. We also offer the fish wire in either 7/16 or 1/2 inch size. The part # for the 7/16 size is 80103-1. The part # for the 1/2 inch size is 80101-1. The bolt would actually thread into the fish wire. view full answer...
I spoke to my contact at Kat's and he told me that the # KH11484 will fit your 2006 Pontiac Gran Prix with the 3.8 V-6 engine. This heater is a frost plug type heater that is designed to replace the original frost plug located on the right side center area of the engine block, (not front center). He also mentioned that may be necessary to temporarily remove the air conditioner bracket to gain access to it.
I have linked the above mentioned product to this page for your convenience. view full answer...
Your concerns about scraping the ground are certainly understandable, so I'm happy to help you out. The Curt # C12225 is going to be approximately 7-1/2 inches from the bottom of the receiver tube to the ground on your 2002 Pontiac Grand Prix. In regard to custom mounts, that's essentially what these hitches are, having been designed specifically for makes, models and years of certain vehicles. There would not be any type of custom hitch specifically made to make the receiver higher. view full answer...
The difference between the SumoSprings Trailer Helper Springs w/ Line Relocation Bracket # TSS-106-40 and # TSS-107-40 is the orientation of the axle to the leaf springs. So since you have an underslung kit the correct part number you need is the # TSS-106-40. The main difference is the height of the spacer that fits below the jounce (blue) spring.
The relocation bracket that comes with these kits is so that you can slightly move a gas or utility line that mounts to the lower portion of... view full answer...
Yes, you can get just the replacement hardware for the Draw-Tite Trailer Hitch, # 24659, to install on the 2001 Pontiac Grand Prix. You will need Replacement Hardware Kit for Trailer Hitches, # RHK. On the product page, insert the hitch number, 24659, in the first box under shipping special. Click the Add to Cart button and that is all you need to do.
I have included a link to the installation details for the hitch and a video showing a typical installation to help you when you re-install... view full answer...
That depends on the weight of your wave runner and trailer. The Curt Hitch part # C12225 that your referenced is a Class II hitch with 3,500 lbs towing and 350 tongue weight capacity. If your trailer falls under those figures, then yes, this hitch would work for you. You will need to also check your owner's manual to determine what your vehicle's towing capacity is as hitches for vehicles do not always have the same capacities.
The lower figure of the two would be your overall towing... view full answer...
The hitch for your 2002 Pontiac Grand Prix is the Curt Class II hitch # C12225. This hitch has a 1-1/4-inch receiver opening and a maximum trailer weight rating of 3500-lbs, which should be plenty for a small rental trailer. This hitch fits several versions of the Grand Prix, the GT Coupe, the sedan and the GTP.
Many of our customer choose to tackle hitch installation on their own, but in the case of your vehicle some drilling is required. You also need a torque wrench to tighten the included... view full answer...
We have what you would need as a replacement passenger side mirror for your 1993 Pontiac Grand Prix Sedan.
If you have a manual mirror you would want the part # KS62521G, if instead your mirrors are controlled electronically you would want the part # KS62533G. view full answer...
If you have the base model (SE) 2006 Pontiac Grand Prix, the Class II trailer hitch with the highest tongue weight capacity is the Curt hitch # C12199 that you have referenced. It has a tongue weight capacity of 350 pounds. But, if the car has a lower capacity, you must go by that. I have included a link to the installation instructions for you.
But for Curt, for any non-trailer load you must use a stabilization strap, # 18050, for the Curt warranty requirements. view full answer...
For your 2003 Pontiac Grand Prix, there are two Class II hitches available.
We have the Draw-Tite Trailer Hitch, # 36241 and the Curt Trailer Hitch # C12225. They both are class II, have a tongue weight capacity of 350 pounds, have a towing capacity of 3500 pounds, and have a 1-1/4 inch hitch opening. They both do not require drilling for installation and need the exhaust to to be temporarily lowered for installation. The Draw-Tite # 36241 is expected to be easier to install than... view full answer...
I have included a link to the installation instructions for the CURT Trailer Hitch, # 12199. We have some square block spacers but not in the size used for this hitch. You will need to order the replacement hardware kit, # RHK, which will include the blocks.
Enter the hitch number and manufacturer where indicated and the correct hardware will be sent. view full answer...
The Curt hitch part #C12225 that you referenced attaches to the frame rails of your 2007 Pontiac Grand Prix and to the trunk floor pan.
If you are close to Wentzville, MO we can install this hitch for you! view full answer...
Most likely yes, the Kuat Adapter bar part # UB01 will provide a horizontal attachment point for a hanging bike rack. A lot of kids bikes have small, odd shaped frames so an adapter bar like this will allow them to be used on a hanging bike rack.
For more info on how this adapter works check out the review video I attached. view full answer...
Hollywood Racks has some trunk mount racks that they indicate will fit your 2002 Pontiac Grand Prix with factory spoiler. You can use the Express 2, # HRE2. I have linked a video review of this rack for you.
If you will be carrying any bikes that do not have a top frame bar that goes straight across (like a typical men's bike would) then I recommend using bike adapter bar # HRBA-PRO. This will allow you to carry those bikes more level and will provide better ground clearance. I have to... view full answer...
Go To Results